The figure to the left
shows the Polyline toolstyle bar. If you have already started to
digitize, hit the Esc key to access the various options. There are
several selections available on the Toolstyle bar. Lines can have
rounded or cut end points. Arrowheads can be inserted at both end-points
or only at the start or at the end. The size of the arrowhead is
configured by altering either the arrow width or the arrow aspect.
Pen style Choose between Solid and Dashed Pen style. The dash and
space length can be configured.
Pen width sets the width of the pen. The size defaults to the
current unit of measurement.
Line ends Choose between Plain, Rounded or Arrowhead. Check the
Equal box for simultaneous configuration of the Start and End style.
Start and End style is used for setting sharp, rounded, or
arrowhead style on the end points.
Arrow size determines the width of the arrow in relation to the
line width.
Arrow aspect (length/width) determines the overall size of the
arrow in relation to the line width.
Coordinate fields Adjust or enter values for exact coordinates.
The color can be configured with the Color Selector (F4
The figure to the left
shows the Polyline toolstyle bar. If you have already started to
digitize, hit the Esc key to access the various options. There are
several selections available on the Toolstyle bar. Lines can have
rounded or cut end points. Arrowheads can be inserted at both end-points
or only at the start or at the end. The size of the arrowhead is
configured by altering either the arrow width or the arrow aspect.